Soft ends

1. Check the bearing cooling water.
2. Use a pusher to offset radial thrust.
3. Make certain that the calender king and queen rolls are not under-crowned.
— use the nip relief properly.
4. It may be advisable, as a temporary measure, to run the sheet with heavy edges on the forming table.
5. Light edges are generally due to the slice width not being sufficient for the trim required on the forming table.
6. Deckles or edge bleeds may not be adjusted correctly.
— there may be a bow wave from the cheeking piece or deckles.
— check for head between the slice and the cheeking piece.